Measured x-over. Not bad.. levels need adjusting and some tweaking to x-o points These are measured at tweeter axis only for now at 0 degrees . 1 meter..
I’ll tweak that out when I get them on the ground. Every time I do these bigger speakers up in the air like that I get them on the ground and the low end is way too loud so I’m waiting.
Comments
Time to button this pair up.
https://www.jfcomponents.com/
How much do they weigh?
I'm guessing easily 100 each.
InDIYana Event Website
Holey Moley
We need some rollie
things to use as feet
My guess is ~125 lbs. That's a lot of particle board and I'll bet that 21" is at least 25 lbs on it's own.
"But will they kill" ? (from the tv show forged in fire)
As they sit in the picture 67lbs. Each. With no backs or drivers.
The 21” weighs 44lbs. By itself. So they should hit 120lbs. by the time I’m done.
https://www.jfcomponents.com/
https://www.jfcomponents.com/
Sorry if I missed it , but , will the bottom opening house the Xover ?
Looks like beefy port to me
There will be a couple of x-overs in there somewhere.
https://www.jfcomponents.com/
.
Sorry the bottom hole is the port.
https://www.jfcomponents.com/
I might have to stop by an enjoy these at some point.
Being a Receiving Clerk, I've seen some funny carrier names... these 2 are the most memorable....
2 Girls and a Truck
Haulin AZ
InDIYana Event Website
It would be funnier if it was . 2 Girls and 1 truck.!
https://www.jfcomponents.com/
I believe that is what he was getting at.
InDIYana Event Website
Let there be measurements ! 😎
https://www.jfcomponents.com/
Wholey work bench Batman
Well got a few measurements before the noise got out of hand.
https://www.jfcomponents.com/
21” sub Dats .
The cabinet volume came in at 6.38cuft. @ 27hz.
https://www.jfcomponents.com/
Dual JF-608’s in a 0.75 sealed with all cabinet walls covered in material and a few strips of denim.
https://www.jfcomponents.com/
Distortion measurements at 1meter 2.8v and on tweeter axis.
https://www.jfcomponents.com/
First X-over with xsim.
https://www.jfcomponents.com/
Measured x-over. Not bad.. levels need adjusting and some tweaking to x-o points These are measured at tweeter axis only for now at 0 degrees . 1 meter..
https://www.jfcomponents.com/
Measured distortion at 3.2v and 1 meter. I will need more power if I want to measure them any louder
https://www.jfcomponents.com/
Those babies are going to shout at the devil around 2k.
I’ll tweak that out when I get them on the ground. Every time I do these bigger speakers up in the air like that I get them on the ground and the low end is way too loud so I’m waiting.
https://www.jfcomponents.com/
https://www.jfcomponents.com/